Additional Info that i missed:
The Pi does have rust over some areas, the audio jack, wifi card etc...
I tried USB booting and the behavior is as erratic as the sdcard booting
I tried a ups hat for ups in case power failure happens, since I get my Pi power from the mains and power cuts are expected.
UPS model and guide here: https://www.waveshare.com/ups-hat-d.htm
I dont believe the UPS hat is not the problem but I am not sure.
If I have to provide any other output let me know
outputs of the following commands
vcgencmd measure_volts
volt=0.8875V
vcgencmd measure_temp
temp=42.8'C
sudo rpi-eeprom-update
BOOTLOADER: up to date
CURRENT: Wed 11 Jan 17:40:52 UTC 2023 (1673458852)
LATEST: Wed 11 Jan 17:40:52 UTC 2023 (1673458852)
RELEASE: default (/lib/firmware/raspberrypi/bootloader-2711/default)
Use raspi-config to change the release.
VL805_FW: Dedicated VL805 EEPROM
VL805: up to date
CURRENT: 000138c0
LATEST: 000138c0
Let me know if I missed anything. And sorry for the bad formatting. I am tired of praying to RPi gods everytime it boots or reboots or if I connect the power supply. It is the only one that I have and have been using it for years. It saved me during my graduate project and I am emotionally attached to it. Every booting is an anxious event.
The Pi does have rust over some areas, the audio jack, wifi card etc...
I tried USB booting and the behavior is as erratic as the sdcard booting
I tried a ups hat for ups in case power failure happens, since I get my Pi power from the mains and power cuts are expected.
UPS model and guide here: https://www.waveshare.com/ups-hat-d.htm
I dont believe the UPS hat is not the problem but I am not sure.
If I have to provide any other output let me know
outputs of the following commands
vcgencmd measure_volts
volt=0.8875V
vcgencmd measure_temp
temp=42.8'C
sudo rpi-eeprom-update
BOOTLOADER: up to date
CURRENT: Wed 11 Jan 17:40:52 UTC 2023 (1673458852)
LATEST: Wed 11 Jan 17:40:52 UTC 2023 (1673458852)
RELEASE: default (/lib/firmware/raspberrypi/bootloader-2711/default)
Use raspi-config to change the release.
VL805_FW: Dedicated VL805 EEPROM
VL805: up to date
CURRENT: 000138c0
LATEST: 000138c0
Let me know if I missed anything. And sorry for the bad formatting. I am tired of praying to RPi gods everytime it boots or reboots or if I connect the power supply. It is the only one that I have and have been using it for years. It saved me during my graduate project and I am emotionally attached to it. Every booting is an anxious event.
Statistics: Posted by Darkwing_909 — Sat Feb 24, 2024 6:20 am