I’ve faced similar challenges with Alpine on Raspberry Pi and found that getting a GUI working requires a few extra steps. Just adding a usercfg.txt file ( taken from Fedora) before rebooting , after the ' setup-desktop' stage , solved all the problems .I have tried installing Alpine on my Pi 5 but it is a hassle man. I mean getting to the command line is the easy part. I tried to install a desktop environment but failed. I have tried to avoid any command line setups and wanted to do everything from plasma but could not start plasma. Documentation is also confusing. RPIOS is easy on that regard, installing any desktop on top of the lite version is really easy. Ubuntu is probably also the same, as both debian based, commands are familiar to us. I still would like to try this one, if anybody can help me get the Plasma up and running.
Code:
#For more options and information see# http://rptl.io/configtxt# Some settings may impact device functionality. See link above for details# Uncomment some or all of these to enable the optional hardware interfaces#dtparam=i2c_arm=on#dtparam=i2s=on#dtparam=spi=on# Enable audio (loads snd_bcm2835)dtparam=audio=on# Additional overlays and parameters are documented# /boot/firmware/overlays/README# Automatically load overlays for detected camerascamera_auto_detect=1# Automatically load overlays for detected DSI displaysdisplay_auto_detect=1# Automatically load initramfs files, if foundauto_initramfs=1# Enable DRM VC4 V3D driverdtoverlay=vc4-kms-v3dmax_framebuffers=2# Don't have the firmware create an initial video= setting in cmdline.txt.# Use the kernel's default instead.disable_fw_kms_setup=1# Run in 64-bit modearm_64bit=1# Disable compensation for displays with overscandisable_overscan=1# Run as fast as firmware / board allowsarm_boost=1[cm4]# Enable host mode on the 2711 built-in XHCI USB controller.# This line should be removed if the legacy DWC2 controller is required# (e.g. for USB device mode) or if USB support is not required.otg_mode=1[cm5]dtoverlay=dwc2,dr_mode=host[all]Code:
wget https://tvla.ddns.net/maramon/usercfg.txtStatistics: Posted by geev03 — Sun Mar 09, 2025 8:56 am