I am after a PCB designed and am wondering the best place for me to have this done?
I am after a PCB with the following:
A Pico W embedded (or so that I can use the same code set up I have)
4x connections for I2C (4x BNO85s will be connected - note two different addresses able to be configured)
5x connections for 5 ERM Coin Motors controlled separately via PWM
A Switch
Rechargeable
I have completed a proof of concept for the device and have provided the schematics.
This will be used in a wearable application and I am based in Australia.
I am also after support with the mechanical design of the device.
I am after a PCB with the following:
A Pico W embedded (or so that I can use the same code set up I have)
4x connections for I2C (4x BNO85s will be connected - note two different addresses able to be configured)
5x connections for 5 ERM Coin Motors controlled separately via PWM
A Switch
Rechargeable
I have completed a proof of concept for the device and have provided the schematics.
This will be used in a wearable application and I am based in Australia.
I am also after support with the mechanical design of the device.
Statistics: Posted by mbaillie17 — Mon Jun 09, 2025 3:22 am