I'm afraid I will have no such luck here, the version I used is the one recommended by the raspberry pi imager for the Pi 3.It's possible that there's a compatibility issue with the Pi 3B v1.2 and the specific version of Bullseye you're using.
I have since also tried an older version of LinuxCNC which others on the respective forums have reported to get up and running on the 3B with some minor tweaks (linuxCNC was the whole reason I decided to dust off this pi in the first place).
Still no success
Statistics: Posted by RBNB — Wed Mar 13, 2024 10:55 am