Look closely at the photos.As a note, move the cell to another place, either under the ethernet port or camera connector. Where it is now it looks to be under the backside of the SoC area.
If you move the cell, then the SoC area can loose heat better from the backside, also it'll not heat the cell up. The ethernet/camera ports is the coolest area of the board.
It does not touch the PCB, it is glued to the bottom of the plastic case.
I've already taken that into account.
Good indication.
1mm separation to PCB
Furthermore, the way I have placed it, the cable is well collected throughout its entire length.
Statistics: Posted by RPIgoodSBC — Thu Mar 14, 2024 10:54 am