I've freshly installed bookworm, 5th december 2023, with the purpose of setting it up via composite out. I tried via raspi-config, didn't work. Tried changing config and cmdline. They look like this? Is there anything wrong with them? I changed dtoverlay=vc4-kms-v3d to dtoverlay=vc4-fkms-v3d. Should it be kms? Anything else look off?
cmdline:
Code:
# For more options and information see# http://rptl.io/configtxt# Some settings may impact device functionality. See link above for details# Uncomment some or all of these to enable the optional hardware interfaces#dtparam=i2c_arm=on#dtparam=i2s=on#dtparam=spi=on# Enable audio (loads snd_bcm2835)dtparam=audio=on# Additional overlays and parameters are documented# /boot/firmware/overlays/README# Automatically load overlays for detected camerascamera_auto_detect=1# Automatically load overlays for detected DSI displaysdisplay_auto_detect=1# Automatically load initramfs files, if foundauto_initramfs=1# Enable DRM VC4 V3D driverdtoverlay=vc4-fkms-v3d,compositemax_framebuffers=2# Don't have the firmware create an initial video= setting in cmdline.txt.# Use the kernel's default instead.disable_fw_kms_setup=1# Run in 64-bit modearm_64bit=1# Disable compensation for displays with overscandisable_overscan=1# Run as fast as firmware / board allowsarm_boost=1[cm4]# Enable host mode on the 2711 built-in XHCI USB controller.# This line should be removed if the legacy DWC2 controller is required# (e.g. for USB device mode) or if USB support is not required.otg_mode=1enable_tvout=1sdtv_mode=2sdtv_aspect=3hdmi_ignore_hotplug=1[all]cmdline:
Code:
console=serial0,115200 console=tty1 root=PARTUUID=cc73a86f-02 rootfstype=ext4 fsck.repair=yes rootwait quiet splash plymouth.ignore-serial-consoles cfg80211.ieee80211_regdom=SE vc4.tv_norm=PALStatistics: Posted by donlombardo — Sat Feb 24, 2024 7:05 am